Bentley 3-litre, 61 airbag fault code :

This page is about Bentley 3-litre air bag problem code 61.

The possible SRS 61 airbag error reason/s;

Intermittent or Repaired Diagnostic Monitor Not Mounted to Vehicle Properly

Internal Electronic Control Module (ECM) fault

Seat belt lock passenger

#61 Airbag Code Repair order ("Recheck SRS at each replacement.")

Remove ash tray from console panel
Using a socket set, remove 4 hex head screws from console panel
Pull console panel out of the two clips
Remove connector from Passenger Airbag Disable module in console panel and take console panel to a work bench
Remove 2 phillips head screws to remove the airbag key module
Carefully unclip the plastic tabs that hold the airbag key module case together
Remove circuit board from airbag key module housing
To prepare the module housing I drilled a 1/4" hole through the clear lens allowing my particular LED to be attached through that hole
Now carefully unsolder the blown light bulb
Then you are able to solder on the new LED *polarity matters* with that in mind the negative on the circuit board is closest to the outer edge of the circuit board
Reassemble the PAD Module and put it back into the console panel and then put everything back together on the dash in the reverse order of removal.

Follow the diagnostic procedures to service the fault condition flashing on the air bag indicator prior to code clearing.
Cycle the ignition switch to OFF and then to RUN.
Observe air bag indicator prove-out (six ? two seconds) followed by diagnostic trouble code (52-85) flashing completely one time.
Locate the Diagnostic "Trouble Code Clear" Connector (grey connector). located underneath the glove compartment, left side (06010) containing Circuits 631 (T/R) and 57 (BK).
Use a jumper wire to short Circuit 631 (T/R) to Circuit 57 (BK) or to another good ground. This short must be made after the diagnostic trouble code flashes completely one time, but before the warning light stays on continuously.
Hold short until air bag diagnostic monitor tone sounds (approximately five seconds).
Release short on Circuit 631 (T/R) to Circuit 57 (BK). This short must be released within 25 seconds after the diagnostic monitor tone sounds.

Diagnostic trouble code is now cleared from memory.